ETNA OM945RVS, Инструкция по эксплуатации

Страница: 50 / 64

EN 20
3. Turn the control dial to the position.
▷ You will hear an audio signal indicating that the Aqua Clean cycle has started. The
symbol will flash slowly and the time remaining to complete the cycle will appear on the
display.
The duration of this cycle cannot be changed. To stop the cycle before it is finished,
turn the control dial to the
position.
▷ When the cycle is finished, the oven will turn itself off, an audio signal will sound and the
symbol will flash quickly.
Attention
Do not open the oven door until the Aqua Clean function is complete. The cooling cycle
is necessary for the function to work properly. Before touching the inside surface of the
oven, make sure that it has cooled properly.
4. Touch any key with your fingertip to stop the audio signal and turn off the symbol.
5. Turn the control dial to the position.
▷ Any traces of dirt and excess water can now be removed from the oven with the damp
cloth.
The Aqua Clean function takes place at a low temperature. However, cooling times can
vary depending on the room temperature. If a deeper clean is required after using the
Aqua Clean function, use neutral detergents and non-abrasive sponges.
Pyrolytic self-cleaning function
This function allows you to carry out a pyrolytic cleaning cycle during which, due to the high tem-
peratures reached inside the oven, accumulated grease undergoes a carbonisation process.
The general recommendation is to perform a pyrolytic cycle every 4-5 uses, using the most sui-
table programme according to the level of stains present in the oven. The more stained the oven,
the longer the duration of the programme. During the pyrolytic cycle the light inside the oven will
remain off.
MAINTENANCE