SAVE THESE INSTRUCTIONS - READ ALL INSTRUCTIONS CAREFULLY
INSTALLATION MANUAL FOR EE202WH-A13BB-GU / LED RUNNING MAN EDGE LIT EXIT SIGN
IMPORTANT SAFEGUARDS
WIRING DIAGRAM
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
• Review the diagrams thoroughly before beginning.
• All electrical connections must be in accordance with local codes,
ordinances and the National Electric Code.
• Disconnect power at fuse or circuit breaker before installing
or servicing.
• Do not use outdoors.
• Do not mount in hazardous locations or near gas or electric heaters.
• Do not let power cords touch hot surfaces.
• Equipment should be mounted in locations and at heights where
it will not be subject to tampering by unauthorized personnel.
• The use of accessory equipment is not recommended by
the manufacturer.
• Do not use this equipment other than intended use.
• All servicing should be performed by qualified personnel only.
• Allow battery to charge for 24hrs before first use.
Head Office -
1850 Wilson Ave. · Toronto, ON · M9M 1A1 ·
Tel:
416.741.7336 ·
Fax:
416.741.9104 ·
Toll Free:
in Canada. 1.800.661.9610 · in USA. 1.888.762.5384 (SOCKETS4U)
www.etlin-daniels.com· For sales/service questions - [email protected]
Blac k Wire (L)
White Wire (N)
Transformer
For batter y
Batter y
Input AC cabl e
MAIN PCBA
Test
red led
LED Stri p
SP
SP
• Emergency duration: ≥ 2 hours
• Recharge time: 24 hours
• Output Wattage: 1W
AC/SP WIRING
CIRCUITRY
Models / Input Voltage
EE202WH-A13BB-GU
AC 120V
50 / 60 Hz
Input Wattage : 3W
Input Current : 0.24A
Efficiency: 0.98P
AC 277V
50 / 60 Hz
Input Wattage : 3.5W
Input Current : 0.014A
Efficiency: 0.93P
AC 347V
50 / 60 Hz
Input Wattage : 4W
Input Current : 0.017A
Efficiency: 0.92P
PS: Battery voltage is negatively relative to input wattage
AC /SP WIRING
Black Wire (L)
AC120V -347V
Whit e Wire (N)
• Light Source: Ultra bright LED
• Color temperature: 6500K - 7500K
• Ni-cad Battery: 3.6V 800mAh jj
1. Attach spider plate / crossbar to junction box, use screws if needed.
2. Feed AC supply wire through canopy center hole.
3. Assemble canopy onto aluminum housing with screws (supplied) and make proper wire connections.
3.1 Black Wire (L); White Wire (N);
junction box
canopy
crossbar
traverse
4. Use screws (supplied) to tighten canopy to mounting plate (spider plate/cross bar)
5. The unit can be installed on any surface, you may rotate the Acrylic panel in any angle from
0 degrees to 180 degrees.
CEILING MOUNT
AC WIRING
Working Voltage:
AC120V - 347V 50Hz / 60Hz
Black Wire (L)
White Wire (N)
--------------------
Green Wire (E)
