
For installation of the appliance, care must be taken not to damage concealed cables.
Please be careful while drilling the holes.
Wall Mount Instructions
This appliance is designed to be fixed to a wall at a minimum height of 300mm and the
minimum distance from the top of the heater to the ceiling should be 1000mm. The
wall bracket must be fitted horizontally and the cable routed to the bottom right of the
heater.
A distance of 600mm from the bottom of the heater to the floor is recommended for
optimum viewing of the fuel bed; see Fig.1 below for recommended fixing
dimensions.
Fig.1
For optimum viewing, mark the top four screws ( fixing positions on the wall in
accordance with the recommended fixing dimension; See Fig.2
-3-
First, Remove the Mounting Bracket
Remove the Mounting Bracket from the back of the Fireplace by removing the two pre -
attached Screws at the back of the unit.
Remove the four white screws that fasten the front panel at both sides.
Fig.2
Note: Ensure the bracket is level by using a spirit level whilst marking out the hole
positions.
Drill holes with a No.6 drill bit.
Fix the wall bracket using the plug and 4x30mm screws provided.
Carefully lift up the heater ensuring the top rear ledge of the heater engages with the
wall bracket(see Fig.3) and is sitting centrally. This process should be carried out by
two people to avoid injury or damage to property or the appliance.
Fasten the small bottom bracket one end on wall with 2 pcs of 4*30mm screws and the
other end on appliance with 2 pcs of 4*8mm screws.(See Fig.4)
Put the crystal to the white boarder , then gently bring the heater down against the wall,
see fig.5
-4-