HAA52N
V. 03
–
08/06/2020
25
©Velleman nv
DC12V
Verbinden Sie den positiven (+) Anschluss mit einer DC-
Stromquelle von 8 V ~ 16 V, die normalerweise vom Bediengerät.
Verbinden Sie den negativen (-) Anschluss mit der
gemeinschaftlichen Erdung des Bediengerätes.
TAMP
NC
Möchten Sie einen Sabotagekontakt, so verbinden Sie diese
Anschlüsse mit einer normal geschlossenen 24-Std.-Schutzzone
des Bediengerätes. Dieser Kontakt ist normal geschlossen, wenn
die Frontplatte am Detektor befestigt ist. Das Öffnen des
Detektors wird diesen Kontakt öffnen und ein Alarmsignal zum
Bediengerät senden.
4.2
Jumpereinstellungen
LED
ON
Die LED ist eingeschaltet.
ON = Alarm eingeschaltet.
FLASH = Einschaltverfahren.
OFF
Die LED ist ausgeschaltet. Beeinflusst die Leistungen
des Detektors nicht.
MODE
OFF
Die LED ist ausgeschaltet. Beeinflusst die Leistungen
des Detektors nicht.
S
Standard Signalverarbeitung mit alternierender
Polarität. Eignet sich für eine stabile Umgebung.
P
Doppelte Signalverarbeitung mit alternierender Polarität.
Eignet sich für eine Umgebung mit wechselnden
Eigenschaften.
ALARM
NC
Dieser Ausgangskontakt ist normal geschlossen. Das
Relais zieht normalerweise an.
NO
Dieser Ausgangskontakt ist normal offen. Das Relais fällt
normalerweise ab.
5.
Installation
5.1
Montageort
•
Der Detektor kann auf einer ebenen Oberfläche, in einer Ecke
oder auf einer Montagehalterung montiert werden. Wählen
Sie immer eine stabile Fläche.
•
Dieser Detektor darf nur im Innenbereich an einem von der
frischen Luft abgeschirmten Ort montiert werden.
•
Wählen Sie den Montageort des Detektors in solcher Weise,
dass jede Bewegung eines eventuellen Einbrechers innerhalb
des Erfassungsbereiches fällt.
•
Setzen Sie das Gerät keinen warmen oder kalten Luftströmen
aus.