ETI 54676341, Инструкция по использованию и уходу, Страница: 7 / 32

7 www.ETiSSL.com
Please contact 1-855-384-7754 for further assistance.
Installation (continued)
EE
AA
A
7
Attaching the housing to the ceiling
□
Drill a 1/8-in. pilot hole into each of the screw locations marked on the ceiling. You can also use an awl or
nail to dimple the screw holes.
□
Install a drywall anchor (EE) and a mounting screw (FF) in each drilled mounting hole, but do not tighten
fully.
□
Align the 2 mounting keyholes on the fixture housing (A) with the 2 mounting screws (FF) in the ceiling.
Once the screw heads are through the large ends of the keyholes, slide the housing (A) until the heads of
the mounting screws (FF) slide into the narrow ends of the keyholes.
□
Finish tightening the mounting screws (FF) until the fixture housing (A) is tightly secured to the mounting
surface.
NOTE: The drywall anchors (EE) are only to be used for mounting the fixture to plaster or drywall surfaces.
8
Reattaching the light engine module
□
Position the light engine
module back inside the
wrap light housing (A)
with the thumbscrews
removed earlier.
□ Tighten the
thumbscrews to
securely fasten the light
engine module in place.
A
Thumb
Screw
Light Engine Module
A
FF