10 / 16
i) Select
measure, the display will show the Mains Input Voltage of phase.
By pressing and holding
, the display will show the total kVA of the system.
By pressing and holding
, the display will show the total kW of the system.
In Manual Mode
press together
and
, the
LED blink and the display will show the maximum
Voltage value.
l) Select
measure, the display will show the Load Current of phase.
By pressing and holding
, the display will show the total kvar of system.
In Manual Mode
press together
and
, the
LED blinks and the display will show the maximum
Current value.
m) Select
measure, the display will show the ambient temperature.
By pressing and holding
, the display will show the total working Hours.
In Manual Mode
press together
and
, the
LED blink and the display will show the maximum
Temperature value.
n) Select
measure, the display will show the Total Harmonic Current Distortion in %.
In Manual Mode
press together
and
, the
LED blink and the display will show the maximum
THD value.
9 - COS
MM
SET-UP AND SENSITIVITY SET-UP:
9.1 Cos
M
set-up:
Press the button
until the LED
turns ON.
Press the button
to increase the value or the button
to decrease the value.
The LED
ON indicates that the instantaneous Cos
M
of the installation is inductive.
The LED
ON indicates that the instantaneous Cos
M
of the installation is capacitive.
9
.
2 Sensitivity:
This value refers to the time that unit takes to measure the average Cos
M
of the installation and do the necessary actions on
the capacitors relays.
The unit of sensitivity is: sec/kvar (The kvar of the lowest capacitor programmed on
3
.
).
>
Press the button
until the
LED lights ON.
>
Press the button
or
to modify the value of sensitivity programmed.
>
The time needed to turn ON the step relay depends on the time of Reconnection of the step. (
3
.
).
ETI Elektroelement d.d. - Slovenija
Tel.: 03/56-57-570- Fax: 03/56-74-077
www.eti.si - [email protected]
