Ethicon Gynecare ThermaChoice II, Руководство по обслуживанию, Страница: 46 / 52

ThermaChoice UBT System Service Manual 4 - 20
P/N 01035 Rev. C
2. Disconnect the Cable from the Micro Board JP2 connection.
3. Disconnect the Cable from the center and 90-degree lugs of the MDU limit switch.
Replacement:
1. Connect the Cable to the Micro Board JP2 connection.
Note:
Due to different lead lengths, observe polarity when connecting the CCS Switch Cable to
the Power Switch.
1.
Connect one wire of the CCS Switch Cable to the center terminal of the Power
Switch.
2. Connect one wire of the CCS Switch Cable to the 90-degree terminal of the Power
Switch.
3. Install the upper half of the case, using the Oval security screwdriver to install the
four fasteners.
Ribbon Cable, 40 Cond. 00874
Warning:
Disconnect the AC power from the device before servicing. Failure to observe this
precaution could result in death or injury.
Required tools: Oval security screwdriver (TR Fastenings, Montgomery Village, MD,
Phone 301-947-1001, Part Description: MonoDrive One)
Caution:
The interior of the instrument is ESD sensitive. Use appropriate ESD precautionary
procedures.
Warning:
Disconnect the AC power from the device before servicing. Failure to observe this
precaution could result in death or injury.
Removal:
1.
Using the Oval security screwdriver, remove the four fasteners securing the upper
half of the case and remove the upper half of the case.
2. At the AUX Board JP4 connection, disconnect the Ribbon Cable.
3. At the Micro Board JP1 connection, disconnect the Ribbon Cable.
Replacement:
Note: