EMCOR Controller Module Description
The EMCOR module was designed to replace the Interface Controller module that resides in slot 00 of
the crate power supply. The EMCOR module will only fit in slot 00 since that is the only location in
the crate with the 2 connectors (P1 and P2) necessary to mate with the EMCOR module. The EMCOR
module will receive the required power needed from the crate power supply via crate connection P1
and EMCOR module connection J2. The EMCOR module will control up to 16 MCOR modules using
a GUI based software such as EPICS and the EMCOR front panel EPICS CA port.
Figure 1--Jumper locations
W7
P2
P10
P3
P4
P1
P11
W3
W8
