Etesia AV95, Руководство пользователя

Страница: 14 / 28

14
1) REMOVAL OF THE SUBFRAME
Remove the bolts and pins (see points A, B, C, D, E of the picture) and
remove the subframe.
2) HST OIL DRAIN
Remove the drain bolt that is located under the HST unit with the 3/8
inches Allen wrench (see point F of the picture) .
Once the bolt is removed, the oil can fl ow out of the HST unit and tank. If
the oil doesn’t fl ow well, remove the cap of the tank.
Once the HST unit and tank are empty, refi t the drain bolt. Tighten the
drain bolt to the torque setting of 34 N.m.
3) FRONT WHEEL UNIT OIL CHANGE (EXAMPLE :
RIGHT SIDE)
There is a drain bolt on each front wheel (see point G of the picture).
Remove this one with the 12mm Spanner.
Once this bolt is removed, the oil has to fl ow out of the unit.
If the oil doesn’t fl ow well, open the venting plug (point H of the picture)
and the oil fi ll plug (point I of the picture).
When the oil stops fl owing, refi t the drain bolt and tighten to the torque
setting of 15 N.m.
4) REPLACEMENT OF THE OIL FILTER
There is a fi lter between the tank and the rear HST unit (point J of the
picture).
The fi lter is held by two collars. Unfasten both collars with the 8mm
spanner or the minus screwdriver. When the collars are loose, remove the
fi lter from the hoses and refi t a new one. Tighten the collars.
5) REFILL THE HST AND TANK
Firstly make sure that the drain bolt (F of the picture) is refi t and tighten at
the recommended torque.
Then remove the tank cap and pour the recommended oil in it up to the
mark « High ».
During the fi lling, make sure that the tank is not polluted (sand, grass, …).
6) REFILLING THE FRONT WHEEL UNIT
First refi t the drain bolt and tighten at the recommended torque. Even if the
oil in the tank fl ows to the front units, it is more effi cient to pour new oil
through point K as well (see the picture). While fi lling the unit, some oil
may fl ow out of the venting plug (point L of the picture) if it is left open.
As soon as oil fl ows out of the venting plug, tighten the bolt. Top up with
oil to be 10 mm below the top edge of the opening. Do the same with the
other front wheel hydrostatic unit.
Check the oil level in the rear tank and top up if necessary to reach the
mark “High”.
6• HST OIL REPLACEMENT AV98X