ETC Installation Guide
Relevé Spot
Relevé Spot
Page 6 of 8
ETC
Power Receptacle/Connector Specification
Power input and power feed through connections are made to powerCON
®
type NAC3MPA-1
and NAC3MCB-1 receptacles on the Power Module. Power In (blue) and Power Thru (gray)
receptacles are keyed differently to prevent intermating.
The luminaire ships with a 1.5 m powerCON power-input cable with a connector of choice. See the
Relevé Spot datasheet for ordering information. Use only compatible power cords with mating
connectors for the specified receptacles.
WARNING:
The powerCON is a connector without breaking capacity, i.e., the
powerCON should not be connected or disconnected under load or while live!
AVERTISSEMENT :
Le powerCON est un connecteur sans capacité de coupure,
c’est-à-dire que le powerCON ne doit pas être connecté ou déconnecté lorsqu’il
est sous tension!
See the following wire color code chart:
Wire Color Code
(International
Standard)
Wire Color Code
(US Standard)
Connection
Type
Terminal
Green/Yellow
Green
Earth/Ground
Blue
White
Neutral
N
Brown
Black
Line (Live)
L
User Interface
The Relevé Spot user interface (UI) consists of a display and button controls for local configuration,
and a USB (type A) port for firmware update. Use the display and button controls to configure the
luminaire for your specific application and installation needs.
Status Screen
When the Relevé Spot is powered up initially, the luminaire runs self tests to check the status of the
features of the luminaire and performs a homing routine. The user interface display shows the
current DMX address, DMX mode, and installed version of firmware. The DMX address will flash
when no DMX is present.
Note:
ETC recommends running the most current version of firmware in your luminaire.
Relevé Spot firmware is available for download from the ETC website
. USB firmware update instructions are provided in the Relevé
Spot User Operations Manual.
