ETC F-Drive W1 Series, Руководство по установке, Страница: 33 / 44

Chapter 4 29
RDM Parameters
Note:
W1 Chroma Driver RDM communication may not function properly if Navis
RGBW luminaires are not set to unique channels using the channel rotary switch on the
side of the Navis RGBW luminaire. See the
ArcSystem Navis 100 Installation Guide for
details on Navis RGBW luminaire installation.
Parameter RDM PID Value Notes
Status Messages
0x0030 See RDM E1.20-2006
Errors will be in the format: "Error type: [data value
1][data value 2]
Root:
•
Board overtemp E120_STS_OVERTEMP[0000]
[Temp degrees C]
•
Emergency Error E120_STS_DIM_PANIC[0000]
[0000]
Subdevices (output channels):
•
Board overtemp E120_STS_OVERTEMP[Sensor
Number][Temp degrees C]
•
Board overcurrent/short circuit E120_STS_
OVERCURRENT[0][0]
Device Info 0x0060 See RDM E1.20-2006
•
Root: reports a footprint of 0 and a start address
of 0xFFFF.
•
Subdevices (output channels): in patched or
straight mode, all output card channels report
their current addresses and a footprint of 1.
•
W1 Chroma Driver will report a footprint of 4 in
IRGB mode or 5 in Direct mode. See
DMX Personality below .
Device Model Description 0x0080 ASCII string for model description
•
Root Device: "F-Drive W1"
•
Subdevices (output channels): the installed card
type that contains the channel.
-
Chroma Card: "Chroma"
-
FTW-150 Card: "FTW-150"
-
CV-150 Card: "CV-150
-
CC-150 Card: "CC-150"
Manufacturer Label 0x0081 ASCII string for manufacturer label Get returns "ETC"from the root only.
Device Label 0x0082 ASCII string for device label
DMX Personality 0x00E0
1= Intensity
2 = Direct (IRGBW)
3 = IRGB
4 = Warm Trim
W1 Drivers
Personalities
Supported
Default
Personality
1 2 3 4
W1 Chroma Driver
✓ ✓
2
W1 Fade to Warm
Driver
✓ ✓
1
W1 CC Driver and
W1 CV Driver
✓
1
DMX Personality Description 0x00E1
DMX Start Address 0x00F0 Range = 001 to 512
Block Address 0x0140 Range = 001 to 512
Sending "set" to root will set the start address of all
outputs sequentially.
Identify Device 0x1000 0 = stop identify Load and LEDs will blink in a 500 ms on and 500 ms