ETC Installation Guide
CueSystem Relay Interface
CueSystem Relay Interface
Page 3 of 5
ETC
Pole-Mount
1. Using the Phillips
screwdriver and the four
M4x8 mm screws,
secure the pole-mount
plate to the back of the
enclosure.
• The pole-mount
plate has round
holes.
2. Place one U-bolt around
the pole.
3. Slide the two holes on
one end of the pole-
mount plate over the U-
bolt, install one washer
on each threaded end of the U-bolt, and install one nut on top of each washer. Tighten to secure.
4. Place the second U-bolt around the pole and slide the bolt ends through the holes on the other end
of the pole-mount plate.
5. Repeat step 3 with the second U-bolt and remaining two washers and two nuts.
C-Clamp
1. Using the Phillips screwdriver and the four M4x8 mm
screws, secure the L-shaped C-clamp hanger to the
back of the Relay Interface.
• Orient the C-clamp hanger with its bent end near
the blank side of the enclosure. Do not orient the
C-clamp hanger with the bent end near the side
with the power input, circuit breakers, and RS232,
USB, and Ethernet ports.
2. Attach a C-clamp to the C-clamp hanger.
3. Attach the Relay Interface to a pipe or other approved
mounting device.
Desktop
Install one rubber foot to each threaded hole at the corners on
the backside of the enclosure using one of the provided
M4x12 mm screws and the Phillips screwdriver.
Step 1
Steps 2 and 3
