ETC Installation Guide
ColorSource Spot jr v2.0/v3.0
4. Press the Mode button to start the update process.
•
The display alternates between
Udt
and the percentage complete while
updating.
•
The display blinks once to indicate that the update is complete.
5. Reconnect DMX In on the fixture.
Restore Factory Defaults
Press and hold the Mode button, Up button, and Down button
simultaneously for 5 seconds. The DMX start address will blink once to
confirm that defaults have been restored.
Error Codes
There are three error codes that may be shown on the user interface.
•
CAL
: Screen toggles between
CAL
and
Err
to indicate a problem with
the color calibration. The fixture will need to be returned to the ETC
factory; contact your local dealer to set up a repair.
•
OtP
: Screen toggles between
OtP
and
Err
to indicate that the fixture
has gone into over-temperature protection mode to avoid damaging the
fixture. Once the fixture has self-cooled, the error will automatically clear.
•
No App
: Screen toggles between
no
and
APP
to indicate that the
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC (visit
).
ColorSource Spot jr
Page 11 of 16
ETC
