ETC Installation Guide
ColorSource Linear Pearl v1.7
ColorSource Linear Pearl v1.7
Page 5 of 20
ETC
Safety cable
Two safety cable anchor points are
provided on the fixture housing.
The anchor points also include two
cutouts that can be used for cable
strain relief.
Connectors
• Power: Two powerCON
®
connectors for power in and
thru
• Data (DMX512/RDM): Two
five-pin XLR connectors
OR
two RJ45 connectors for data
in and thru
Conversion cables are available from ETC. Please contact your ETC customer
service representative and request part number W6538 for RJ45 to female
XLR or part number W6539 for RJ45 to male XLR.
Connector locations
• Linear 1: Power connectors on one side of the fixture and data
connectors on the other
• Linear 2 and Linear 4: Power and data connectors on each end (to
facilitate daisy-chaining)
Note:
This fixture is not Ethernet/data network compatible.
Note:
The ColorSource Linear Pearl is not self terminating. You
must terminate the last fixture in line with a 120 Ohm
resistor. XLR terminators are not available from ETC.
To purchase an RJ45 terminator, please contact ETC
customer service and request part number N4086.
Safety cable
anchor point
C-clamp
attachment
point
Cutout for
cable strain relief
