ETC Installation Guide
ColorSource Linear Pearl v1.7
ColorSource Linear Pearl v1.7
Page 20 of 20
ETC
Quick reference
DMX control channels for Linear 1 and Linear 2/Linear 4 in
Group mode
*Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase
the strobe rate from 1 per second up to 33 per second.
Error codes
There are three error codes that may be shown on the user interface.
•
: Screen toggles between
and
to indicate a problem
with the color calibration. The fixture will need to be returned to the
ETC factory; contact your local dealer to set up a repair.
•
: Screen toggles between
and
to indicate that the
fixture has gone into over-temperature protection mode to avoid
damaging the fixture. Once the fixture has self-cooled, the error will
automatically clear.
•
: Screen toggles between
and
to indicate that a control
card or the internal cabling is damaged or unplugged. Verify that
internal cables are properly connected. If the error persists, the fixture
will need to be returned to the ETC factory; contact your local dealer
to set up a repair.
•
: Screen toggles between
and
to indicate that the
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.
DMX
Channel
(Variable
Color Temperature)
(Direct)
(1 Channel)
1
Intensity
Intensity
Intensity
2
Color temperature
Warm white
3
Cool white
4
Strobe*
