34
CEM3 User Manual
Patching
Patching governs the relationship between control sources (DMX A, DMX B, and sACN) and the rack’s
circuits, and is editable from the CEM3 face panel. Typically, repatching is used in portable rack
situations where the dimmer rack must adapt to different control sources and lighting systems. For
permanent rack installs, repatching is rarely needed.
You can patch racks that have only one assigned space using one of two methods: manual or
automatic. Racks with multiple assigned spaces can only be edited manually. For racks edited using an
automatic method, circuits will be numbered sequentially from the specified starting address following
the designated Balance setting (Straight, 1-Phrase, or 3-Phase) in Quick Setup. See
.
Any circuit set to a patch of 0 cannot be controlled from the data source specified.
Automatic Patching
Automatic patching is the final step in the Quick Setup utility. See
Manual Patching
Manual patching allows you to patch on a circuit-by-circuit basis. There are two independent options
for manual patching: DMX and sACN. Both can be set individually for your needs.
1:
Navigate to [Setup]>[Patching], and then select either Edit DMX Patch or Edit sACN Patch.
2:
Press [Enter]. The Select Space screen will appear (if multiple spaces exist).
3:
Select the desired space (if applicable) and then select OK
.
The Patch Table will open.
4:
Use the scroll wheel or keypad to select the DMX port (A or B) or sACN universe and channel for
the desired circuit.
5:
Press [Enter]. The field will become editable.
6:
Scroll to or enter the desired channel from the keypad.
7:
Press [Enter].
8:
Repeat steps 4–7 for all desired circuits in the space.
9:
Press [Back] when done. A confirmation dialog will open.
10:
Select the appropriate option:
• [Yes/Save]: Save the changes
• [No/Cancel]: Cancel the changes
• [Continue Editing]: Edit additional circuits
11:
Repeat steps 2–10 for any additional spaces.
Note:
Module density can affect patching. Prior to patching, make sure you set up the
module type in [Setup]>Circuit Assignment.
Содержание CEM3
Страница 1: ...Part Number 7140M1200 1 7 0 Rev C Released 2019 04 Sensor3 CEM3 User Manual Version 1 7 0...
Страница 82: ...76 CEM3 User Manual...
Страница 83: ...PhaseAdept Dimmer 77...
