ETC 7121A1212, Руководство пользователя, Страница: 18 / 32

14 ColorSource ThruPower User Manual
From Dimmer
The From Dimmer menu allows you to select the dimmers for which you will configure the
output. To select the dimmers:
Step 1: Scroll to From Dimmer and then press the [Enter] (

) button.
Step 2: Press the [Increase] (+) or [Decrease] (–) button to scroll through the dimmer
numbers, and then press the [Enter] (

) button to set the first dimmer in the
range.
Step 3: Repeat the preceding step to set the last dimmer in the range.
Dimmer
The output will dim according to the curve setting selected in the dimmer Curve menu (see
on
page 14
). The relay will not close at any level, including at full.
Relay
While the control level is below the threshold configured in the Threshold menu, the relay is
switched off. When the control level reaches the threshold, the relay is switched on.
See
“Threshold” on page 16.
.
TPAuto
With ThruPower, dimming is operated between the DMX levels of 0 and 254, while latching
the relay at DMX level 255. TPAuto can be used to allow the configuration of dimming verses
relay mode, which can be stored as part of console show files for consoles that do not have
RDM functionality available.
Output Setup
From Dimmer: 1 to 1
Mode: Dimmer
Curve: Mod-Square
Emergency Yes
Threshold 1%
Output Setup
The Output Setup menu is used to set circuit-
related parameters.
Mode
Dimmer
Relay
TPAuto
Always On
Off
Mode
The Mode menu allows you to select and apply
the output mode to the selected circuits.
Curve
Mod-Square
Linear
Preheat
Fluorescent
Curve
The Curve menu allows you to select and apply one
of four curves.