Etatron eSelect M 1 CD COOL, Инструкция по эксплуатации и техническому обслуживанию

Страница: 27 / 36

30
ENGLISH
Press ◄ ► to select the days of activity ◄ ► N no or Y yes
Confirm by pressing OK , automatically goes to the next step
Weeks 1:S 2:N 3:N 4:N
Selects the weeks of the month during which the connected equipment is operational
Press ◄ ► to select the weeks of activity ◄ ►
N no or Y yes
Confirm by pressing OK , automatically goes to the next step
Press to go back to or press MEASUREMENT DISPLAY
BIOCIDE MENU > PRE-PURGE > TIME LOCK
BIOCIDE 1 BIOCIDE 2
Menu Selection Menu Selection
BIOCIDE 1 BIOCIDE 2
BIOCIDE 1 MENU
Pre-Purge is a safety function: if the conductivity level is lower than the
BIOCIDE 2 MENU
Pre Purge
selected EC setpoint it allows the drain operation before dispensing the
Pre Purge
0 μ S
biocide and after disabling the purge SV. It prevents wasting chemical
0 μ S
biocides uselessly in the event the SV should open at the same time, during
or just before the start of the biocide activation time.
BIOCIDE 1 MENU
Output time lock mode: SV purge, inhibitor dispensing and Biocide2
BIOCIDE 2 MENU
Time lock
dispensing operations are blocked for the duration of Biocide1 dispensing
Time lock
000 :00 (m: s)
operations, thus preventing a waste of the chemical product while allowing its
0
μ
S
disinfection cycle to be completed at the same time.
BIOCIDE MENU BIOCIDE MENU
Flow Sensor Flow Sensor
Enables or disables the Flow sensor function (proximity probe). The flow
Disabled Enabled
sensor is useful in the event of water lack in the probe socket; the proximity
probe disables all outputs ensuring no chemical substance is added.
BIOCIDE MENU
Max Manual Time
Overwrites the previous SV programming (timer or conductivity), selecting the maximum SV opening time and
000 .00 (m: s)
manual start-up (next step). It is a safety measure in the case where the operator opens the SV via the Max
manual programming and forgets to close it.
BIOCIDE MENU BIOCIDE MENU
Supersedes the previous Max Manual Time programming and SV
Manual Start-up Manual Start-up
programming (timer or conductivity). The operator manually selects when
OFF ON the SV is ON / OFF. "Manual ON / OFF start-up" only works if the previous
function" Max Manual Time" has been programmed.
Press to go back to or press to go back to
READ THE MESSAGE CAREFULLY, THEN PRESS OK TO START
To go forward quickly, press and hold one of the ◄► buttons
CONDUCTIVITY SENSOR CALIBRATION > EXPERT MENU
ESC ESC M E A S UR E M E N T D I S P L A Y
M E N U S E L E C T I O N
ESC
M E N U S E L E C T I O N ESC
ESC ESC to go b a c k to
30