Etatron DLX pH-RX-CL Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 49 / 60

• 45 •
7.5 - RESET PROCEDURE
The pump is equipped with two RESET procedures. It can be used any time the user has to reset some or entire calibration parameters.
Following are described all the steps for partial RESET and for total RESET:
• In order to exit this mode, hold down keys + and -.
7.6 - STAND-BY PROCEDURE
• Turn off and turn on the pump
• Press at the same time button + and button - (user has15 seconds
• Press once the OK button , it will appear SETPOINT menu
to make this operation after pressed OK button).
• On the display will appear RESET
ATTENTION: after 15 seconds from entry in SETPOINT menu
the reset procedure.
(2)
• Hold down key + and - until Stand-by appears on the display
(3)
(1)
• Press twice - button and then Right arrow button
7.5.1 Partial RESET procedure
With this procedure a partial reset will be activated, the pump return to the default settings but all the calibration
parameters will be saved.
(2)
• On the display will appear RESET
(3) (1)
• On the display will appear SELECT
With this procedure the pump is put on stand-by.
ENGLISH
it isn't possible to activate the reset procedure. Therefore the
user has to turn off and then turn on the pump and to repeat
7.5.2 Total RESET procedure
With this procedure a total reset will be activated, the pump return to the default settings and all the calibration
parameters will be lost.
• Press twice + button and then Right arrow button
• On the display will appear RESET
• On the display will appear SELECT