Page 30 of 45
User manual
Chair
operation
The stand up function:
1.
Move the seat and back to the required starting
position (cf. sections 5.2.1 and 5.2.2)
2.
Move the footrest to the required starting
position (cf. sections 5.2.3 and 5.2.4)
3.
Activate the seat raise function (cf. section
5.2.5).
4.
Raise the seat until you are at the correct height.
The correct height is indicated by a yellow light
which comes on in the vertical function panel
(1).
5.
Push the lower part of the lock pin up, so that it
sticks straight out (2a). Thread the buckle of the
knee brace cushion into the fixing bracket. Push
the lock pin back, so that it remains straight up,
with the broadest part of the lock pin facing
down. The lock pin is now in the lock position,
and the knee brace cushion is ready for use of
the stand up function (2b). The knee brace
cushion must be tight below the knee.
6.
Put on the breast belt (3) and tighten it
7.
Activate the stand up function by holding down
the stand up function switch (4).
8.
Move the chair to the upright position, the
support legs (5) will automatically be lowered
when the seat angle exceeds 15 degrees. A
green light (6) comes on when the support legs
are activated.
Return to the starting position:
1.
Press and hold down the switch (7) to deactivate
the standing position and return to the starting
position.
