eta x472, Руководство пользователя, Страница: 25 / 48

25
GB
/ 44
Dust container
– Tip out the arrest closure A10 . Hold the container B by the handle B1 and insert it into
the suction space of the vacuum cleaner (pic. 16).
– Tip the arrest closure A10 back.
– Proceed reversely when removing the container.
Synthetic dust filter
– Tip out the arrest closure
A10
. Hold the front of the filter
D
and insert it (direction of the
arrow) into the suction space of the vacuum cleaner (pic. 20).
– Tip the arrest closure A10 back.
– Proceed reversely when removing the filter.
ATTENTION
– It is always necessary to disconnect the suction hose F2 from the vacuum cleaner before
replacing accessory (dust containers B or synthetic dust filter D ).
– It is necessary to insert the delimiting cassette C into the suction space instead of
cassette E with micro filter E1 before installing the dust container B into the vacuum
cleaner (pic. 2).
– It is necessary to insert the cassette E with micro filter E1 into the suction space instead
of cassette C before installing the synthetic dust filter D into the vacuum cleaner (pic. 3).
– Safety feature A9 will not allow closing the vacuum cleaner lid if you forget to insert the
dust container or dust filter.
– Make sure that the bearing area and sealing elements are functional.
IV. USING OF THE VACUUM CLEANER
Remove all packaging material, remove the vacuum cleaner and accessory. According to
your desired activity, insert dust container B and cassette C into the suction space (obr.
2) or dust filter D and cassette with micro filter E+E1 (pic. 3). Pull out a necessary length
of the supply cord A13 and plug it into a socket. Assemble the accessory of the vacuum
cleaner. If the model of the vacuum cleaner is equipped with a telescopic suction tube F3 ,
adjust it to your desired length (pic. 7). Floor nozzle
F1
is intended for vacuuming carpets
or smooth floors (obr. 8). If the floor nozzle is equipped with a brush, pull it out by switching
the flap before vacuuming hard floors. Slid nozzle G3 is intended to vacuum places that
are hard to access (pic. 9). Cushion nozzle G1 or joint brush G2 may be used to vacuum
various types of furniture (pic. 10, 11). Turn the vacuum cleaner on/off by pressing the
switch button A4 marked with “ ” symbol (pic. 12). You may control the suction power
by the handle regulation on the hose holder F2 (pic. 13) or by setting the rotating regulator
A6 (pic. 12). We recommend minimum suction power for fine fabrics (e.g. curtains,
drapes). We recommend maximum suction power for floorings (e.g. commercial carpets).
After finishing vacuuming, unplug the vacuum cleaner. When pressing the A5 button with
symbol “ ” (pic. 12) the supply cord will wind in automatically. You may hold and transfer
the vacuum cleaner by handles A8 .
N ote
If the supply cord does not wind in completely. Release the A5 button, pull the cord approx.
by 50 cm out of the vacuum cleaner and press the A5 button again.
Full dust filter signaling
If the coloured field is displayed permanently on the indicator A7 (Fig. 14) while the
floor nozzle is lifted above the cleaned surface at the maximum suction power, the dust
container must be replaced. Disregard changes on the indicator during vacuuming.