–
Steam ironing is not suitable for fabrics from synthetic and silk fibers (e.g.
acrylon,
nylon, polyamide, spandex, elastane or polyester
). If you decide to iron such
materials, you have to set the thermostat control dial
A2
to the one dot symbol and press
the button for low steam generation
B2
.
– Iron white and light materials on the right side; it is better to iron dark and embroidered
materials on the wrong side, it brings out the patterns.
– We recommend using soft textile permeable base materials for steam ironing.
– Make sure that the ironed fabric is tensed up properly so that steam does not leak to the
sides.
– For the ironing plate to remain smooth, protect it from direct contact with hard objects
(e.g.
zip fasteners, buttons, snap buttons, decorative objects
). To put the iron aside,
use the resting plate of the boiler that is equipped with anti-slip pads and designed to
withstand very high temperatures.
Ironing without steaming (dry ironing)
Connect the power cord plug
B9
to the power supply, press button
B1
; you will hear
a sound signal (beep), the power supply connection indicator
B5
will turn on and the low
steam indicator in button
B2
will be lit intermittently (flashing). Place the iron in the resting
position (Fig. 5 A, B). Set the level according to the selected material on the thermostat
control dial
A2
(Fig. 2). When the set temperature is reached, the indicator
A3
will switch
off.
WARNING
–
During ironing the thermostat will cycle, which is accompanied by characteristic sound
(clicking). This is normal situation and does not form the reason for warranty claim
related to the appliance.
– The electronics of the appliance will evaluate ironing without steaming (dry ironing) as
if the appliance has not been manipulated with for a longer period of time and it will
automatically disconnect the appliance from the power supply after 10 minutes. To
activate the appliance again, press button
B1
or hold the steam control
A4
down for 1
second anytime in the interval from 0 to 10 minutes from the last activation.
!
Recommendation
Control
A2
(Fig. 2) is marked with international symbols that recommend the optimum
ironing temperature and they are the same as marking on some types of laundry
and textiles (Fig. 3). When the temperature is increased from the cold state or if the
temperature is set from higher to lower, we recommend waiting for a while (see the
information on the display and listen for sound signalling) due to stabilization of the
ironing plate
A1
temperature.
i
Filling up the tank with water
Pull the water tank
C
out (Fig. 4) and take off the cover of the water funnel
C1
. Pour clean
tap water into the tank up to the line (MAX 1.7 L) and close the funnel cap with
a snap. Insert the tank into the boiler in a reverse way, end-to-end. We recommend diluting
hard tap water with distilled water. You can obtain information on the water hardness from
the water supply network manager, or at a hygienic station. We recommend filling the iron
according to the following ratio when the water hardness is > 15 °N:
30
GB
/ 58
