Warning
– Use the
steaming
function only if is shown on the display
STANDARD
or
STEAM MAX
.
– Be extra careful to avoid accidental pushing of the
SELF CLEAN
button.
– At places with hard water we recommend diluting it with distilled water. You will get the
information about water hardness at the water-management authorities, or at the local sanitary
station. For water hardness
> 15 °N
we recommend filling the iron in the following ratio:
Water hardness
Ratio of tap water : distilled water
medium
2 : 1
hard
1 : 1
very hard
1 : 2
Sprinkling appliance (additional spray)
It is used for moistening fabrics and it is effective in ironing extremely creased fabrics. It is
activated by repeated pressing of additional spray button
E
. We do not recommend applying
additional spray for fine fabrics (e.g.
silk and synthetic
) as the used water may stain the fabric.
Intensive steaming (steam shock)
Use only if the steam ironing is insufficient. In this case press intensive steaming button
F
several times (Fig. 6A –
). Thus you will get additional steam except for the steam
created by standard steaming.
Warning
When you press intensive steaming button
F
several times, water may drip from the ironing
plate due to excess water in the steam chamber. Do not consider this as faulty operation.
VERTICAL SYSTEM
It is intensive vertical steaming for steaming of freely hanging textiles (such as hanging clothes,
draperies, hangings). Using buttons
H
set one of the programs for steamig. When you hear
a sound signal (indicating reached selected temperature), press button
PUMP
D
and
signaling light will come on. Hold the iron in your hand. Stretch the fabric slightly with one
hand and move the iron vertically bottom-up (Fig. 6B –
). Press the intensive steaming
button
F
so that you reach vertical steam hammer. Do not hold the intensive steaming button
pressed continuously and do not use it more than 10 times consecutively.
WARNING
– Prevent burning of sensitive fabrics, do not close them to the iron to distance of 10 to 20 cm.
– Use the VERTICAL function only if is shown on the display
STANDARD
or
STEAM MAX
.
!
Self-cleaning system
(
SELF CLEAN
)
Hold the iron disconnected from power supply in your hand and lift off cover
C
to open the
filling container lid. Pour water into container
I
using the enclosed cup
O
to fill half of it and
close the filling hole lid (Fig. 4) by snapping it.
Keep the position of the iron for pouring
water in it
. Plug power cord
M
into a socket. Put the iron to the rest position (Fig. 7) and
using
H
set one of the program
STEAM MAX
.
When you hear a sound signal
(indicating reached selected temperature), disconnect the iron from the electric power. Hold
the iron in the horizontal position over a sink. Press the
SELF CLEAN
button repeatedly (two
to three times), each time for about 5 seconds. Then wait till water stops going out from the
ironing plate. If the iron still contains a lot of impurities, repeat the procedure while pushing the
intensive steaming button between individual pushing of the
SELF-CLEAN
button.
26
GB
/ 47
