After completing the cleaning, plug the iron into the electric power, set the selected program
and then iron a clean piece of cotton cloth so that the ironing plate is cleaned.
Clean the
ironing plate using the SELF CLEAN function continuously.
Safety electronics
(
AUTO STOP
)
The safety electronics ensures switching OFF the iron plate heating within 30 seconds,
when the iron is left without any movement in horizontal position or when it is tilted over to
one side, or within 8 minutes, when it is left in vertical position. Function of safety electronics
is signalled by flashing of display
G
and by acoustic signal (beep). The iron is restarted
automatically, when the ironing is resumed.
Storage
After finishing ironing, pour out the unused water from the container (be careful, it can be
hot), or let the rest of the water evaporate and let the iron cool down. Then turn regulator
D
to
O
position (steam switched off). Wind power cord
M
over the back side of cover
L
and
put the iron to the rest position (Fig. 8) out of reach of children and incapacitated persons.
IV. MAINTENANCE
Before every maintenance, unplug the iron from power supply by taking the fork of
the power cord out of the socket! Do not use rough and aggressive detergents
(e.g. sharp objects, peelers, pot scourers, caustic agents for cleaning or other
solvents).
Wipe the entire iron with a wet cloth in the cooled state and dry up. If brown film
is created on the ironing plate (e.g. when ironing starched laundry), you can remove the film
by a detergent containing fine sand. The iron is equipped with a permanent decalcification
system
ANTI CALC
that does not require maintenance. But the system cannot fully prevent
creation of calcareous sediments.
V. TROUBLESHOOTING
Problem
Cause
Solution
Iron is not heated. Power supply not connected
Check the cord, plug and the socket
Display shows STAND BY sign
Set suitable program with buttons
H
AUTO STOP function activated
Move the iron for deactivation of the
safety function
Iron does not
create steam
There is no water in the container Pour water into the container
The steaming function is OFF
Use button PUMP
Low temperature is set for
activating the DRIP-STOP
function
Set a program by the button
+
, during
which you can use steaming and wait
till the iron is heated for using it
Iron does not
create steam
shock
The steaming function is OFF
Use button PUMP
Low temperature
Set a program by the button
+
, during
which you can use steaming and wait
till the iron is heated for using it
The function of steam shock was
used too often during a short
period of time
Let the iron heat and wait for a while
before using the electric shock
function again
GB
27 / 47
