eta Brilanto 2v1, Инструкция по эксплуатации

Страница: 23 / 64

Emptying dust container
If you find out that the suction performance of the vacuum cleaner is reduced,
make sure that the dust container is not full and if necessary, empty it. Release locking of
container
B by pressing button A3 and remove it from the vacuum cleaner by tilting
(Fig. 14). Pull out HEPA-filter B1 and filter protector B2 from the container (Fig. 15), then
place the container over a dustbin and empty it into common municipal waste (Fig. 16).
For sanitary reasons we recommend emptying the container outside housing premises.
Cleaning dust container and cleaning filter
After the container has been emptied about 5 times we recommend complete cleaning of
the suction system from the settled dust. Clean all parts (i.e. the container, the HEPA filter,
the filter protector=cyclone unit can be cleaned by tilting off the lid) in running lukewarm
water (e.g. using a cloth or a fine brush) and let it dry completely (Fig. 17, 18).
Reassemble individual parts in the opposite direction after it is completely dry.
Storing accessories
Put the accessories ( E , E1 , E2 ) to the holder F (Fig. 19). Store battery charger H at a safe,
dry and dust-free place inside a house, keep it out of reach of children and incapacitated
people.
V. MAINTENANCE
Unplug the battery charger or the automatic cable from the appliance before any
maintenance. Store the vacuum cleaner at a dry place, far enough from heat sources
(e.g.
fireplace, stove, heating element ) and protect it against weather conditions
(e.g. rain, sunshine ). Treat the surface of the vacuum cleaner and the battery charger
(only when disconnected from the electric socket) with a soft and wet cloth, do not use
abrasive and aggressive cleaning agents! Never dry plastic moldings over a heat source
(e.g.
heater, electric/gas stove ).
Floor nozzle
After every vacuuming it is recommended to check the brushes or collectors for possible
impurities visually. If you find some impurities, remove them in the way specified below.
Turn the screw in the lower part of the nozzle in the direction of the symbol " " , then
remove the fastening clamp (Fig. 20). Now you can remove the brush from its position and
clean it. Insert the brush to the nozzle in the opposite direction and secure it properly.
CAUTION
- The maximum suction effect will be reached with a clean filter and an empty container.
- Do not use any aggressive washing or cleaning agents or hot water to clean the filter.
- The filter is not intended for washing in a dishwasher.
- The dust container is not resistant to cleaning in a dishwasher.
- Cleaning the filter will not restore its original colour, but it will restore its filtration
properties.
- Neglecting filter cleaning may lead to breakdown of the vacuum cleaner!
- Make sure that the contact surfaces and sealing elements are functional.
- We recommend replacing the filter twice a year or when it cannot be cleaned properly
or if it is damaged. You can buy a replacement filter in the elektro shop chain.
23
GB