Estella 236ECEM1, Руководство пользователя, Страница: 7 / 15

6
CLEANING &
MAINTENANCE
1 . Wipe machine exterior with soft, slightly dampened cloth daily before starting
operations .
2 . If necessary, a mild, non-corrosive cleaning agent may be applied to the cloth .
DO NOT spray cleaning agents directly on the machine body to avoid corrosion and
possible damage to circuits .
1 . Rinse the handle with hot water after each brewing cycle to dissolve residual oils in the
filter basket and outlet nozzle and prevent oils from affecting the quality of coffee .
2 . Disassemble filter basket handle and filter basket . Immerse both in cleaning solution
(3tsp of detergent in 1 pint hot water) for 24 hours to dissolve residual coffee oils .
DO NOT immerse plastic portion in cleaning solution to avoid deterioration .
3 . Rinse all components with clean water . Wipe with a soft, clean cloth only .
1 . After each brewing cycle, remove the handle and press the manual water output button
to remove all residual coffee grounds from the filter element .
2 . Then fix the handle to the seat again
CAUTION: DO NOT force handle or fix it into the seat too tightly .
3 . Press the manual water output button, shake the handle to clean the handle seat gasket
and remove residual coffee grounds from the inside .
4 . Flush the steam outlet in REVERSE daily before shutting off the machine .
5 . Remove the copper plate and filter element from the water outlet .
WARNING: Metal may be hot .
6 . Place a reverse flushing silica plate in the filter cup, and apply about 2-3 grams of
detergent . Fix the handle into the seat and check for tightness .
7 . To dissolve residual detergent in the machine, press the manual water output button for
approximately 4 seconds and release . Repeat this process several times . Press the manual
water output button and shake the handle to clean the gasket and the inside of the
brewer . Continue the process until water in the filter cup is clear and clean .
8 . After cleaning, remove the handle . Press the manual water output button to allow
residual cleaning solution in the brewing system to flow out . Turn water off after flushing
for about one minute .
a . During reverse flushing, remove and wash the copper plate and filter element
with clean tap water . Wipe with soft cloth .
b . If process is unable to sufficiently clean the plate and filter element,
immerse the components overnight in a mild cleaning solution of 3 tsp detergent
in 1 pint hot water .
9 . Rinse and reassemble components before restarting the espresso machine .
MACHINE BODY
BREWING SYSTEM
FILTER BASKET & BASKET HANDLE