Estella 235ECB2D, Руководство пользователя

Страница: 10 / 22

9
DRAINING
When the brewer needs to moved, repaired, de-scaled, or emptied for extended storage,
the remaining water in the boiler tank can be released following the steps below:
1. Unplug the power cord from the electrical socket and let the brewer cool down for at
least 40 minutes to avoid any burn injuries.
2.
front cover. Remove the front cover.
3. A white water pipe tube and hose shutoff clamp can be seen inside of brewer . (Figure 1)
4. Fasten the white shut off clamp at the end of the drain hose. (Figure 2)
5. Look for a connector in the front of water tube clips with a metal clamp . Press down on
the metal clamp and move slightly to the end of tube. (Figure 3)
6. Place the end of the drain hose in a container that has a capacity of 3 gallons or more .
7. Release the white clamp to drain water out from the tank.
8. When the water tank is empty, move the drain hose back to the original position . Then,
press down on the metal clamp and move it back to the original position .
9. Check that the white shut off clamp has been loosened.
10. Replace the front panel and tighten the screws.
11.
Figure 1 Figure 2 Figure 3