Estate Swing E-S 1600 Series, Инструкция по эксплуатации

Страница: 49 / 50

The manufacturer instructions that come with your accessory should have markings for wires
or terminals to connect to the gate opener. Please look for terminals named below in the in-
structions for the accessory.
Keypads, Receivers:

Normally Open (NO) or Input (INP) or Relay of entry device = OPENA ter minal of CN4
block on gate opener control board.

Common (COM) or Ground (GND) or Relay of entry device = COM ter minal of CN4
block on gate opener control board.
NOTE: If the power for the accessory shares a Ground wire/terminal with the relay – Do Not
power that accessory off this control board (example: WKP-P keypad). Instead power that device
with batteries.

24V Power positive (+) or (24V) or (PWR) of entry device = +24V ter minal of CN1 block
on gate opener control board.

24V Power Negative (-) or (GND) or (PWR) of entry device = -24V terminal of CN1 block on
gate opener control board.
Push Button, Intercoms:

Normally Open (NO) or Input (INP) or Relay of entry device = OPENA ter minal of CN4
block on gate opener control board.

Common (COM) or Ground (GND) or Relay of entry device = COM ter minal of CN4
block on gate opener control board.
Push buttons do not require power and Intercoms draw too much power to power from the
gate opener.
Exit Wand/Sensor, Exit Loop Detector, Exit Device:

Normally Open (NO) or Input (INP) or Relay of exit device = OPENA ter minal of CN4
block on gate opener control board.

Common (COM) or Ground (GND) or Relay of exit device = COM ter minal of CN4 block
on gate opener control board.

24V Power positive (+) or (24V) or (PWR) of exit device = +24V ter minal of CN1 block on
gate opener control board.

24V Power Negative (-) or (GND) or (PWR) or Shield wire of exit device = -24V terminal of
CN1 block on gate opener control board.
Accessories Wiring
6.4