Espa DRAIN, Инструкция по эксплуатации

Страница: 10 / 36

10
EN
7. PLATE SHOWING CHARACTERISTICS
DESCRIPTION
1 Item reference
2 V fre item specifications
3 Flow
4 Pressure
5 Nominal voltage, no. stages, alternate current symbol and frequency
6 Capacitor (Single-phase model)
7 EC mark
8 Humidity protection level
9 Maximum pressure
DESCRIPTION
10 Year and week of manuf Pump serial number
11 Max. liquid temperature
12 Max. immersed depth
13 Electric pump unit absorbed power (P1)
14 Designated motor insulation
15 Continuous operation symbol
16 Maximum nominal intensity at nominal voltage
17 Name and address of vendor responsible for the product
8. POSSIBLE FAULTS, CAUSES AND SOLUTIONS
1) The pump does not start.
2) Pump runs but there is no flow.
3) Pump stops automatically.
4) Pump does not deliver rated capacity.
9. TECHNICAL DATA
Liquid temperature… ...................... 4ºC - 35ºC
Ambient temperature: ..................... 0ºC - 40ºC
Storage temperature: ................... -10ºC - 50ºC
Ambient relative humidity, max.: ............... 95%
Motor class
I .
Other data see Figure 1.
1 2 3 4 POSSIBLE PROBLEM SOLUTIONS
X Lack of electricity Replace fuses or switch RCCB (30mA)
X X Improper thermal protection Switch thermal protector or check that voltage is correct
X
Float switch disconnected Wait for water level to be back to adequate level
X X Wet end blocked Call Service Engineer
X Blocked float switch Check the free operation of the float switch
X Disconnected discharge pipe Connect it and fix the discharge pipe correctly
X Air trapped at the pump body Move the pump laterally to empty the air
X
Check valve assembled way round Assemble the valve correctly
X Pump partially covered of water Submerge the pump or wait to have the suitable level
X X Inlet filter obstructed Clean the suction filter
X
Total manometric head higher than
expected Check the geometric head and loss of head
X Impeller worn Contact a Service Engineer
X Deteriorated discharge pipe Replace it by a new one