Esoteric Grandioso T1, Руководство пользователя

Страница: 18 / 84

18
17
Place the power supply unit near the base unit
and connect it to the motor unit with the DC
power cord (page 8).
When using a clock generator, connect it to the 10MHz IN
connector.
18
Use a phono cable (sold separately) to connect
the tonearm with a phono amp or the phono
input of an amp.
Use a commercially-available phono cable for connection.
o
Always connect the grounding wire of the phono cable, too.
19
While preventing the motor unit from moving
by, for example, holding it down by hand, pull
out the installation rails.
o
If the motor unit is moved while pulling out the installation
rails, put the rails back into their original positions. Insert the
motor unit until there are no spaces between it, the platter
and the spacer block. Then, pull out the installation rails.
20
Remove the spacer block from the platter.
Installation (continued)
21
Remove the protective covers attached to the
base unit at the locations shown by the arrows.
22
Place the turntable mat on the platter.
23
Adjust the tonearm.
o
Refer to the owner’s manual for the tonearm being used and
adjust it.
o
After completing all connections, plug the power plug into a
power outlet.
ATTENTION
Save the tools used for installation because they will be needed
when relocating the equipment.
Adjusting the distance between the plat-
ter and the magnetic driver
Adjusting the distance between the platter and the magnetic driver
will change the sound when a record is playing.
The default position is 3.
The adjustment range is 2–3.
Set the micrometer adjustment knob to the desired position.
0
0
Increase distance Reduce distance