KK-EPA.004 Rev No:0 28.09.18
18
6.5.4. Analogue Output Scale Setting
On the device with the analogue output feature, to set the output signal to the desired scale range, SCALE
mode on this menu must be ON. Then S-LO. and S-HI. values can be entered.
6.5.5. Wave Function
On this menu, you can find the linear standard waveform which is in the factory setting ; you can set as
the sine, cosine or triangular format.
Press the PRG button after selecting
ON with the direction buttons
When you press
and hold to the PRG
key the value in the
second line starts
blinking. Enter the
desired value using
the UP and DOWN
buttons.
Press and hold the UP button to move
to the next step.To enter a negative (-)
value, move to one of the non-digit
digits and press the DOWN button.
The decimal point starts flashing. Use the UP
and DOWN buttons to select the decimal digit
point.
S-LO.
0.20
The new S-LO
value you
confirmed with
the PRG button
has been set. You
can return to run
mode with the
ESC button.
* After you have set the S-LO value, you can do the same for the S-HI value.
SCALE
ON
SCALE
ON/OFF
S- LO.
0
20
20.
0.20
OUT
LINER
SIN.
When you press and
hold to the PRG key
the value in the
second line starts
blinking. Select the
desired wave form
using the UP and
DOWN buttons.
Press and hold the PRG button.
anlog
Vave.f.
SIN.
The new wave form you confirmed with
the PRG button has been set. You can
return to run mode with the ESC button.
Vave.f.
LINER
0
