Esko Kongsberg XL, Руководство по обслуживанию, Страница: 12 / 59

i-XL Service Guide
12
3.3 Set the Main reference point on a table with rulers
3.3.1 If your table is running XL-Guide
10 mm/0.4 inch
Ruler
Main reference point
The Main reference point is set 10 mm / 0.4 inches inside the ruler in both axes:
1.
Go to Option, Table setup, Set Reference point.
2. Select reference point 1 and follow the instruction on the screen.
3.3.2 If your table is running i-Cut
Reference point 2
I-Cut reference point =
Main reference point
Unfortunately, the Main reference point for i-Cut and XL-Guide are in different positions on the table.
In order to run both i-Cut and XL-Guide on the same table, we have to follow these rules:
1.
The Main reference point on the table (Ref. point 1) is set using the i-Cut Main Reference -
button as described above. Do not modify the position of Reference point 1 after this initial
setting.
2.
As reference point when running XL-Guide select any of the other reference points available, for
instance Reference point 2. Go to Option, Table setup, Set Reference point.
Select reference point 2 and follow the instructions on the screen to set reference point 2 10 mm
/ 0.4 inches inside the ruler.
3.3.3 Execution
After the initial setup, follow these rules:
1.
When running i-Cut, select reference point 1 on the table.
2. When running from XL-Guide, select reference point 2 on the table (or the reference point you
selected during setup).
Note: The working area for i-Cut is somewhat smaller compared to the working area for XL-Guide.