Esko Kongsberg XL, Руководство по обслуживанию, Страница: 10 / 59

i-XL Service Guide
10
2.7 The vinyl roll holder (optional)
A roll holder for vinyl rolls is available.
The distance between the rolls can be changed
to suit different roll sizes.
Roll diameters up to ø200 mm is possible.
Note: The weight of the roll has to be
considered. If heavy weight, the acceleration of
the belt movement should be reduced.
Reduced acceleration is also recommended to
avoid material spin-off.
2.8 The sheet feeder (optional)
MGE offers a sheet feeder that can be mounted on the rear side of the cutting table.
You can load a stack of material into the sheet feeder. The feeder will lift one and one sheet onto
the cutting table where the conveyor belt system moves the material into the working area of the
machine.
The interface between the sheet feeder and the i-XL table is just one control signal.
In addition, there is an USB – connection between the sheet feeder and the front end PC.
2.9 The kiss-cut tool (optional)
The kiss-cut tool was developed as part of the i-XL, but the tool is also available for XL. The kiss-cut
tool is a special tool for vinyl cutting. You will find a detailed description of the tool and how to use it
in chapter 8.