*
if the sensor or actuator supports Auto-E-Connect. For details, please refer to the operating instructions of the sensor or actuator.
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change.
ESERA GmbH 2021
www.esera.de
11603-48 V1.0 R1.1 Manual
Page 16 of 18
16
Firmware-Update
The latest device software (firmware) can
be found in the download area of the
Config Tool 3. Please check for a new
firmware version when commissioning
the ECO 208 PRO.
Please use the latest version. The
firmware update is carried out via
Config Tool 3.
Please observe the operating instructions
for the Config Tool 3, which you can find
within the Config Tool 3
under the tab "HELP/SUPPORT".
You can find a video about the firmware
update on our website under
"Service and Support, Support Videos".
16.1
Recovery function Firmware-Update
If the update is faulty, e.g. due to a power failure during the update, you can use the
recovery function. To do this, press and hold the reset button (this is located under
hole 5 on the top of the module), start the update in Config Tool 3 and release the
reset button after approx. 1 second after starting in Config Tool 3. The update should
now start.
If you have any problems with the installation, we will be happy to help you. Simply
contact our support team by e-mail at [email protected].
17
Example for integration in Codesys
We would be pleased to provide you with a test software for the integration of the ECO 208 PRO into the PLC
software Codesys. Please contact our technical support under
18
Example for integration in Siemens SPS
For many years, the Modbus TCP protocol has also been available in the programming environment of Siemens
PLCs. The Modbus addresses of the ECO 208 PRO have been adapted to the requirements of the Siemens
programming environment. Therefore, this combination is also possible and has already been implemented by
many customers.
19
Example for integration in KNX Automation
For integration into a KNX automation system, we offer a software module for the Gira Homeserver together with
Grot compnay. This provides you with a very powerful 1-Wire integration for your KNX system. Details can be
found on the ESERA website under "Compatible controls / Control units / KNX Gira
Homeserver“.
https://www.esera.de/cat/index/sCategory/339
Note
Please also note the operating instructions for Config Tool 3, which you can find within Config Tool 3
under the "HELP/SUPPORT" tab.
Furthermore, you will find a video about the firmware update on our website under "Service and
Support, Support Videos".
Note
After performing an update, we recommend disconnecting the ECO 208 PRO from the power supply for
approx. 30 seconds and restarting it.
Pressing the reset button does not correspond to an interruption of the power supply.
