Art.No.11603-48
*
if the sensor or actuator supports Auto-E-Connect. For details, please refer to the operating instructions of the sensor or actuator.
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change.
ESERA GmbH 2021
www.esera.de
11603-48 V1.0 R1.1 Manual
Page 3 of 18
2
Auto-E-Connect Support
The ECO 208 PRO 1-Wire Controller supports Auto-E-Connect Level I, II and III.
3
Auto-E-Connect System
With the launch of the ECO Controller, the ESERA Auto-E-Connect® 1-Wire Plug and Play system for the
1-Wire Bus is now introduced and supported.
This means that fully automatic configurations of the 1-Wire devices* (sensors and actuators) are now
possible on the 1-Wire Bus. It is optimised for commercial and industrial applications and enables significant
added value beyond sensor and chip data.
The Auto-E-Connect function is built up in three levels. Currently there are Level I, Level II and Level III
available.
With Auto-E-Connect Level III, fully automatic configurations of the 1-Wire devices on the
1-Wire Bus are possible. It is optimised for industrial and IoT applications and enables significant added
value beyond sensor and chip data.
With the Auto-E-Connect function, ESERA devices are recognised fully automatically, suitable libraries are
started and ready-formatted data is output.
The Auto-E-Connect functionality will be available for the ECO Controller and ESERA-Station 200 Pro from
2021.
Auto-E-Connect Level I
OWD Detect
: Detection of new sensors* and actuators* and automatic start of adapted libraries
Auto-E-Connect Level II
Visualise product data
: Readout and visualisation of Auto-E-Connect and manufacturer data of sensors* and
actuators*, such as article number, date of manufacture, firmware and hardware version.
Auto-E-Connect Level III
Extended Plug and Play System for 1-Wire Bus
o
Pre Configuration
: The OWD number for the next installation can be written into the 1-Wire device*.
o
Automatic Positioning
: The device* logs on to each ECO controller with Auto-E-Connect III with the new
desired OWD number. This automatic registration works up to the maximum possible OWD number of the
ECO Controller.
o
Sensorfinder Function
: The ECO 208 PRO can activate a status LED within the ESERA 1-Wire Pro
sensors*. The status LED flashes or lights up permanently for a certain time. This makes the detection of a
device in a 1-Wire Network much easier. Faster detection saves a lot of time and therefore money when
searching for a 1-Wire device.
o
Classes Assignment
: ESERA 1-Wire devices are assigned to OWD classes with the same properties. This
assignment enables fully automatic visualisation and data evaluation in control systems. A class list is
available from ESERA.
For further information on the ESERA Auto-E-Connect system, please refer to the ESERA website and the
ESERA Config Tool 3.
Auto-E-Connect is registered by ESERA GmbH as a German and European Patent.
