6.4 Securing of mounting rail
1. Position the mounting rail on the mounting brackets. Make sure that the mounting bracket and the mounting rail are
precisely at a right angle to each other. The mounting bracket can be rotated slightly because it is only attached by the
upper screw.
2. Take care that the end of the mounting rail protrudes approximately 5 cm over the last mounting bracket.
3. Snap the mounting rails one after another to the mounting brackets. There has to be a clear “click”! The mounting
brackets can be sprayed with silicone spray to make the snapping easier.
4. Ensure that the mounting rails are perfectly aligned.
5. Screw the lower self-tapping plate screw 6.0 x25mm to the mounting brackets. (see appendix on page 14)
6. As soon as the rubber on the screw distorts, the screw is tight and the roof is watertight.
Pay special attention to placing the mounting rails straight over each other so that the solar panels can be perfectly aligned!
09
Rev. 20.01.14
ASSEMBLY MANUAL FOR STEEL ROOFS
Click !
min. 30 cm
4
e
3
e
2
e
1
e
1
2
3
4
5
6
5 cm
1
2
3
4
5
6
