ESD QUICK 713, Инструкция по эксплуатации

Страница: 3 / 26

2
Ⅰ. Summary
Thank you for purchasing the unit which including the soldering iron part, de-soldering gun part
and SMD rework part. It is a good assistant. The three tools can work at the same time.
Ⅱ. Safety Instruction
z
Please use the unit only as the described manner, and avoid abusing it.
z
The unit shall only be used with rated voltage and frequency. (Refer to the trademark back of the equipment.)
z
The unit is equipped with a 3-wires grounding plug and must be plugged into a 3-terminal grounded socket.
Do not modify plug or use an ungrounded power socket. If an extension cord is necessary, use only a 3-wire
extended grounding cord.
z
When the power is on, do not touch the metal part because the temperature of the tip, or the nozzle, or the
sucking nozzle will be up to very high, which may be hurt you.
z
Do not wet the soldering station. Don’t use or disconnect it with wet hands, and without to force the supply
cord.
z
Advise other people in the working area to turn the power off when in a break or after using the unit because
the unit can reach a very high temperature and may cause potentially dangerous.
z
No replace any parts or install the tips before turning the power off and cooling down the searing-iron to room
temperature.
z
Do not use the unit near the flammable items.
z
The soldering process will produce smoke, so make sure the area is well ventilated.
z
A periodically maintenance (description see in this manual) of the unit is necessary. Do not use the unit if it is
damaged, especially the power supply cord and the case.
z
Do not modify the unit by oneself.
z
Replace only with genuine parts.
z
Children do not recognize the risks of the electrical appliance. Therefore use and keep the unit out of the
reach from children.
TOOL1 KEY
AIR KEY
TEMP KEY
VACUUM KEY
INFO KEY
SOCKET OF
SOLDERING POWER
SWITCH
TOOL2 KEY
TOOL3 KEY
SOCKET OF
DESOLDERING
TOOL
FIKTER SOCKET of
DESOLDERING TOOL
HANDLE OF SMD
REWORK