MAW
®
User Manual Rev. 3.0
14
10. Do not use this product at temperatures exceeding 30.0
o
C.
11. Place this unit in a location with adequate ventilation to prevent internal heat build-up.
Allow at least 10 cm clearance from the rear, 30 cm from the top and 20 cm from left and
right to prevent overheating.
12. This unit is intended for indoor purposes only.
13. Read the section about EMC in this IFU on section 27 and heed the warnings.
9.3 Post installation
1. Refer all servicing procedures to a qualified service personnel.
2. Servicing is required according to the Service manual as well as in cases when the device
has been damaged in any way, e.g. if the device has been dropped, exposed to rain or mois-
ture, or does not operate normally. MAW, Multi-zone ART Workstation
®
contains high volt-
age components that may be hazardous.
3. Unplug this apparatus during lightning storms or when unused for a long period of time.
4. Protect the power cord from being walked on or pinched
–
particularly the plug, conven-
ience receptacles and the point where it exits from the apparatus.
5. Perform temperature and gas calibration at the intervals described in the manuals.
6. NEVER block gas supply holes in tabletop.
7. Make sure that CO
2
gas supply pressures are kept stable at 0.6 bar (8.70 PSI).
10 Getting started
MAW
®
, Multi-zone ART Workstation,
must be installed by an authorized and
trained personnel only!
1. Follow the guidelines in the safety instructions and warnings section.
2. Connect the mains cable to the top of the workstation for the fan unit work.
3. Connect the mains cable to the underside of the tabletop for PC and tabletop heating sys-
tem to work.
4. Connect the gas line to premixed gas (in case of MAW
®
with gas mixer, connect to CO
2
and
N
2
gases).
5. Set the gas pressure on the external gas regulator at 0.6 bar (8.70 PSI).
6. Switch on MAW
®
with the ON/OFF switch under the tabletop (next to the mains cable).
7. Power up the PC by pressing the button in the middle of the inner wall working area.
8. Observe for normal functionality.
9. Let the unit warm up and stabilize for 20 min.
10. Follow the guidelines in the Validation guide.
11. Complete user training and finish reading instructions.
12. After a burn-in phase of 24-hours, the unit is ready to be used IF the testing is successful.
