G8872_1 Installation Manual AUS
5
Cleaning the log set and glass:
NEVER EVER RUB THE FASCIA
The outside of the fascias must only be cleaned with a damp cloth. The high temp silver
powder coating that is used on Escea fascia parts contains certain amounts of aluminium
that when rubbed too hard will oxidise leaving a big black smudge that cannot be
removed.
This is a service procedure that will need to be carried out when ever soot builds up on logs
and/or inside of glass.
If soot build up becomes excessive or regular then one of the following actions may be required;
•
Reset gas pressure, pressure may be too high;
•
Reposition log set so that front edge of each log is just behind each row of holes in burner
top;
•
Clear any blockage from primary air port of burner;
•
Check to make sure flue system is drawing well.
Step 1:
Lift off the inner fascia by unscrewing the
two screws situated underneath. pull
the base of inner fascia out by
lifting it up and off.
Step 2:
Unscrew the top glass
retainer and remove it. Take
care that the glass does
not fall forwards at this
stage.
Step 3:
Lift out glass and place it carefully
aside.
Step 4:
Take out log set and gently brush any
soot from log with a soft hearth brush.
The burner tops can be vacuumed to
remove any excess material.
Step 5:
Clean the inside and outside of glass with
normal glass cleaning products. use a
CLEAN
DRY
cloth only. Stubborn marks may be cleaned
with a ceramic glass cleaner.
