3
8.
Rotate U-support #7 until you see the screw hole in
the slot of U-clip #3. Slide U-support #7 side to side
if necessary.
9.
Insert screw #19 through slot in U-clip #3 and into
U-support #7. Thread it all the way into U-support
#7 until it touches the back of the tube. There should
be about 3/8 inch of screw #19 left sticking out. Re-
peat for U Leg #2 and U-clip #34.
Figure 5
34
3
Note:
To aid in assembly you can use a cordless drill and
Phillips bit for
Step 9 only
.
Wear safety glasses
.
If you want to see a video on how to insert Screw (#19) go to:
http://www.escaladesports.com/customer-service/videos.html
Note: Slide U-Support back and forth until
you see the hole (if necessary).
5a.
6. Line up holes in rails with pilot holes in top and secure using
eighteen screws #20. See Figure 3.
Figure 4
7. Lay Corner Caps #22 on table as shown in Figure 4. If Corner
Cap sticks above table top surface of table, flip over so shorter
distance is against edge. Secure to bottom of table with three
screws #21.
DO NOT
over tighten Screws.
5b.
Figure 3
This end is the
middle of the table
Short
er D
istan
ce
Lon
ger
Dis
tan
ce
20
35 (RH)
Slide Left #36 and Right #35 Vinyl End Caps onto the ends of
the Side Rails #25 as shown.
Lay out rails #25 and 26, as shown in Figure 3, around edges
of table top.
