5.
Lay out Side Rails #25 and End Rail #26, around edges
of table top as shown in
Figure 3
.
6.
Slide Left #33 and Right #32 Vinyl End Caps onto the
ends of the Side Rails #25 as shown in
Detail C
.
7.
Line up holes in rails with indentations in top
and secure using eighteen screws #20. See
Figure 3
&
Detail C
.
8.
Lay Corner Caps #22 on table as shown in
Figure 3
. If Corner Cap sticks above the
table top surface of the table, flip over so
the shorter distance is against edge. Secure
to bottom of table with three Screws #21.
See
Detail D
.
25
26
21
25
Note:
Rails attach
with #20 screws
7
Note:
Rails attach
with shorter #20
screws
20
33 (LH)
20
Detail C
Shorter Distance
Detail D
Longer Distance
20
32
(RH)
3
Figure
20
HARDWARE NEEDED
#8 X 7/16” Screw
(
Qty. 18
)
20
HARDWARE NEEDED
#8 X 5/8” Screw
(
Qty. 6
)
21
Note
: This is the end of the
table with no rails.
Shorter
Longer
Note:
Corner Caps
attach with longer
#21 screws
20
6
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREW IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
NOTICE
