2.
Align U-Support (#7) and U-Leg (#2) on Table
Top as shown in
Figure 1
.
1.
Lay table top #1 painted side down, on a smooth, flat
surface. Use the shipping container to protect the
painted surface of the table top.
End Rail Mounting
Indentations
Note:
Indentations are
small so look closely.
1
2
13
7
3.
Put plastic caps (#13) on the end of
U-Leg (#2). See
Figure 1
.
NOTE:
“U-Leg” (#2) is larger and Wider
than the “U-Support” (#7). The U-Leg
should be installed on the end of the table
half with the end rail mounting holes.
(U-Support)
(U-Leg)
Note:
U-Leg
(#2) is
larger
and
Wider
than th
e U-Su
pport (#
7).
1
Figure
Note:
Indentations are
small so look closely.
ASSEMBLY TIP
The following pages will have a picture of the
Hardware Needed
(to scale) along with the
Quantity, Key# and Description. You can lay the
hardware on the picture to identify the hardware.
ASSEMBLY TIP
Table top can be set on two saw horses.
Although this will make
assembly easier it is not necessary to complete assembly. Always use
shipping container to protect the painted surface of the table top.
CAUTION:
Make sure that the table top is secure on the
sawhorses and NEVER leave the table top unattended.
CAUTION:
4
