8. Slide Fiberglass Rods #17 together and insert into Sleeve #18. Next insert one end of the fiberglass rod #17 and sleeve
#18 into the triangular pocket on the
upper outside corners of the net. The rod will then remain on the front of
FRONT
the net until it reaches the
diagonal square from the lower inside corner as shown in
. Push it though this
second
Detail 6
hole and down into the fiberglass rod pivot connector. Then carefully take the fiberglass tube sleeve and slide it over the
pivot connector as well. Do this for both sides. Make sure to slide part #17 (Rod Sleeve) over pivot connector as well. At
this point the Yard Guard should be free standing.
Detail 6
Second
diagonal
square
Detail 7
Detail 6
17
17
18
*Rim
& Net
not
shown
for
clarity
.
For systems with a hoop light only.
6. Using a ladder take the upper pole bracket #16 with Protective
surface facing the pole, slide the shorter U-bolt #15 through
bracket to attach the Nets as shown in
. Attach nuts so
Detail 4
that the bracket may still move up and down. Carefully position
assembly so that net is fairly tight and most of the slack is
removed. At this point tighten nuts snug so that the U-bolt and
bracket cannot move.
the grommet in the net.
DO NOT CRUSH
Detail 4
7. If using a hoop light remove the
nuts as shown in
LOWER
and attach net to lower U bolt on Light Bracket as
Detail 5
instructed on Step 6.
Detail 5
Step 6.
Detail 4
Detail 5
For systems with a
.
hoop light only
For systems with a
.
hoop light only
Figure 3
4
5
14
16
15
13
4L-81
56-00
WA
RNIN
G
!
13
14
Warning
label
Logo
Protective Surface
6
SKIP TO PAGE 11
TO CONTINUE THE INSTALLATION
Содержание Goalrilla B2800W-2EF
Страница 15: ...15...
