The sheet metal Tower
can flex to get
(#22)
wider or narrower, on units with a 72” or 60”
backboard the Tower will need to be flexed out
to fit the brackets. On units with a 54”
backboard the Tower may need to be flexed in.
Make sure the bracket is centered from front to
back, then tighten
&
Nylon bolts.
front
back
Lastly, tighten
bolt until the brackets
middle
are completely secure. See note below.
TOWER
STEP 3
STEP 4
OR
Insert Tower
into the opening of the
(#22)
Bracket
. On one side, line up the two
(#21)
holes in the Tower to the two centering
indentations in the bracket, then do the same
for the other side until both sides of the tower
are in the bracket.
NOTE:
TIGHTEN BOLTS UNTIL SECURE BUT
,
DO NOT OVER TIGHTEN!!
THIS COULD
CAUSE YOUR POST BRACKET TO DEFORM.
If this happens, loosen bolts until bracket
regains its shape and tighten back up slowly
until it is firmly on pole.
9
NOTE:
Tower will deform permanently.
Assembly tip:
Lifting each bracket up
separately and then sliding it back into place
can assist in this process.
NOTE
FT
:
When tightened the bolts on model
72
will stick out more than on smaller units.
22
22
22
21
21
NOTE:
Inside the bracket there
will be “centering indentations”
that will need to be lined up with
the holes in the Tower for the next
step.
Inner
Centering
Indentations
21
Back
Bolt
Front
Bolt
Middle
Bolt
Содержание Goalrilla B2800W-2EF
Страница 15: ...15...