Escala PL160R, Руководство по установке

Страница: 36 / 106

1 Rack-mounting bolt 7 Leveling foot
2 Thin washer 8 Lower plastic isolator bushing (used
only on dc-powered systems)
3 Top plastic isolator bushing 9 Stabilizer brackets
4 Thick washer 10 Threaded hole (used to secure the
rack to mounting plate.)
5 Spacer 11 Anchor bolt hole
6 Jam nut 12 Traced pattern (pattern to be traced
onto the floor using the mounting
plate as a template)
30. Using your anchor bolts, secure the back stabilizer bracket on top of the raised floor and through to
the concrete floor.
31. Replace all raised-floor panels that may have been removed when aligning and securing the anchor
bolts to the concrete floor.
32. Align the rack over the front and back stabilizer brackets.
33. Insert each of the bolt assemblies through a leveling foot.
34. Align the rack-mounting bolts with the threaded holes in each stabilizer bracket. Turn each bolt three
to four rotations.
35. Tighten the locking screw on each caster.
36.
Adjust the leveling feet downward as needed until the rack is level. When the rack is level, tighten
the jam nuts against the base of the rack.
37. If you have multiple racks that are connected as a suite (bolted to each other), go to “Connecting
multiple racks with rack-to-rack attachment kit” on page 21. Otherwise, torque the four bolts to
40-50 ft-lbs (54-67 nm).
38. If you are not installing doors on your rack, install the top, left, and right trim panel.
Figure 18. Securing the rack to the floor.
26
Installation Guide for the 03E/4A, 07M/15, and 08M/25