ESAB SCT-4200 Series, Инструкция по эксплуатации, Страница: 6 / 32

6
OPERATING DATA, CLEANING DATA, AND PART NUMBERS
GENERAL NOTES:
1. Pressures given are measured at the torch; there-
fore, pressure drop through hose should be consid-
ered when setting pressure at the regulator. Gener-
ally, 1/4-in. hoses up to 25-ft. long are adequate for
cutting steel up to 4-in. thick. If longer hoses are
required and if cutting thicker steel, 3/8-in. hoses
should be used. If using low-pressure fuel gas,
3/8-in. fuel gas hose should be used for all cutting
operations.
2. The table shows average values based on typical
conditions. The type and quality of steel, its surface
condition, the purity of the oxygen, etc. will always
have a bearing on the end results.
4216 Series Fuel Gas One-Piece Cutting Nozzles
NOTE: Primarily designed for use with Propylene or MAPP
4217 Series Fuel Gas Two-Piece Cutting Nozzles
 If using LPNG injector (19417) in torch, it will operate with natural pressure less than 1/2 psig.

Use soft-bristled brush (750F99) to clean preheat slots of internal nozzles.
   

  
   
  ­€   ­€
­ €

 ­€‚‚
Nozzle Steel Pressure, psig Gas Consumption, ft
3
/hr Cleaning
Thickness, Drill Size
Size Part No. in. Oxygen Fuel Gas Oxygen Fuel Gas Preheat Cutting


Nozzle Sleeve Steel Pressure, psig Gas Consumption, ft
3/
hr Cleaning
Nozzle (Internal) (External) Thickness, Fuel Gas Fuel Gas Drill Size
Size P/N P/N in. Oxygen FG-2 Propane Nat. Gas Oxygen FG-2 Propane Nat. Gas Cutting•
1/4" 19485 19518 1/4" 30 4 6 7 70 8 12 30 68
1/2" 19486 19518 1/2" 35 4 7 8 120 9 14 32 60
1" 19487 19518 1" 40 4 8 9 180 10 15 35 53
2" 19488 19518 2" 45 5 9 10 250 11 16 40 50
4" 19489 19519 4" 40 4 8 10 370 12 18 45 43
6" 19490 19519 6" 50 5 12 13 520 14 20 50 39
8" 19491 19519 8" 50 6 15 16 610 16 22 55 35
12" 19492 19519 12" 75 8 18 20 860 20 30 85 31