ESAB PEH 4.3, Руководство по обслуживанию, Страница: 45 / 74

-- 45 --
fzb2d3ea
Example 1
System1
(PEH1 and Welding power source no. 1)
System2
(PEH2 and Welding power source no.2)
Weldhead offset
S
Press start for both PEH1 and PEH2 at the same time.
S
System1 starts welding.
System2 doesn’t start welding until it has reached the starting point for System1
(the distance is set in “Weldhead offset”).
S
Press stop for both PEH1 and PEH2 at the same time.
S
System1 stops welding while the travel motion continues.
System2 stops welding when it has reached the point where System1 stopped
welding (the distance is set in “Weldhead offset”).
S
The weld is finished.
Example 2
When using a remote control box (RCC) the two systems must be connected to each
other (see manual A2- A6 Process Control System article no. 0458 081 074).
System 1 System 2
bus bus
DIG I/O 1 DIG I/O 2
D7 C2
When using an RCC one can when necessary use only Welding power source 2.
S
Set “Weldhead offset” to 0 in the menu for PEH2 .
S
Press start for Welding power source 2 on the RCC.
System1 starts to move and System2 starts to weld
S
Press stop for Welding power source 2 on the RCC to finish.
GB