ESAB PEH 4.3, Руководство по обслуживанию, Страница: 43 / 74

-- 43 --
fzb2d3ea
2. Max weld voltage, dv (valid when Other has been selected)
Max weld voltage that is allowed to be entered into the control box (20.0--60.0 V).
Note that this affects the resolution.
3. Min weld voltage, dv (valid when Other has been selected)
Min weld voltage that is allowed to be entered into the control box (0.0--30.0 V).
Note that this affects the resolution.
4. Max ref voltage, dv (valid when Other has been selected)
Max reference voltage out (1.000--10.000 V).
Reference voltage out from the PCB depends on which welding power source that is
being used.
PEH
bus
Analogue PCB
C15
C16
C12
C13
Welding power
source
(not LAF/TAF)
Reference
Start/ Stop
Example:
Max requested reference voltage is 0--5 V, write 5000 in the menu.
The lowest requested weld voltage is 15 V, write 150 in the menu.
Max requested weld voltage is 50 V, write 500 in the menu.
Program version 4.0, 4.01: Program version 4.2, 4.3, 5.0, 5.1:
Power source type Other
Max weld voltage, dv 500
Min weld voltage, dv 150
Max ref voltage, mV 5000
Power source #
Power source type Other
Power source #
Wire Creep Speed
Max weld voltage, dv
500
Min weld voltage, dv 150
Max ref voltage, mV 5000
5. Wire creep speed (Valid for PEH4.2, PEH4.3, PEH4.3C)
Used for setting the desired wire creep speed of the feed motor at the start.
Entering for example the value 10 into the Wire Creep Speed menu will result in a
creep speed of 10 cm/min.
The preset value 0 will result in a creep speed calculated according to the set
welding data.
GB