ESAB Origo Feed 30, Инструкция по эксплуатации

Страница: 7 / 19

-- 7 --
OF30e
Application class
The symbol indicates that the power source is designed for use in areas with increased
electrical hazard.
4 INSTALLATION
The installation must be executed by a professional.
WARNING!
This product is intended for industrial use. In a domestic environment this product may cause radio
interference. It is the user’s responsibility to take adequate precautions.
WARNING!
When welding in an environment with increased electrical danger, only power sources intended
for this environment may be used. These power sources are marked with the symbol .
a. Connect the wire feeder with the welding rectifier. Temporary keep the
current cable disconnected.
b. Connect the wire feeder to gas regulator by means of gas hose.
Attention: Use gas heater only for pure CO2.
c. Connect a welding torch. If it is liquid--cooled, connect its hoses to
appropriate connectors, turning aside an arm of the pump switch (ELP).
Hoses and appropriate connectors are marked in red and blue.
d. Install the bobbin with electrode wire.
e. Input the wire between the rolls and further to the torch connector, at least
for 20cm inside. Type of the rolls should match the side and the type of used
electrode wire. Take in account, that for convenience, marking on the side of
the rolls corresponds the size of the groove on the opposite side.
f. Close the rolls and adjust an optimal radial pressure by means of knobs.
Setting recommendation is placed on the inner side of the cover.
g. Set braking force of the wire bobbin by means the bolt placed inside the
bobbin holder.
Attention! Keep attention during replacement of the bobbin. Don’t use gloves
while installing the bobbin and inputting the wire into the torch.
h. Set mode selector (2) in position (inching). Press the torch switch and let
the wire go through the torch up to its appearance out of the torch.
i. Set mode selector (2) in position (gas purge). Press the torch switch and
adjust the gas flow.
GB