ESAB MultiMaster 160, Инструкция по эксплуатации

Страница: 16 / 32

16
4.1.4 SECONDARY WELDING CONNECTIONS
The secondary output welding terminals, POS (+) and
NEG (-) are located in the lower front panel. Refer to Po-
larity Setup.
4.1.5 WIRE FEED SPEED CONTROL (Figure 8)
The wire feed speed control potentiometer located in the
upper left-hand side, allows wire feed speed adjustments
between 65 and 650 inches per minute (IPM).
4.1.6 VOLTAGE CONTROL (Figure 9)
The arc voltage is controlled with this knob when the Pro-
cess selector switch is in the MIG position. Refer to Weld
Chart and set the recommended setting.
4.1.7 CURRENT CONTROL (Figure 8)
The welding current is controlled with this knob when the
Process selector switch is in the STICK OR TIG position.
Refer to Weld Chart and set the recommended setting.
4.1.8 HOT START (Figure 8)
The Hot Start feature is used to control the amount of
starting current in the Stick welding mode. This helps
ensure positive arc strikes for difficult to start electrodes
and also allows for softer starts on thin material.
SECTION 3 INSTALLATION
4.0 OPERATION
4.1 STANDARD CONTROLS
4.1.1 POWER ON/OFF SWITCH & LAMP
The main power switch is located on the front panel in the
lower right-hand corner. This switch energizes the main
transformer, control circuitry and illuminates the switch
face.
4.1.2 TEMP LAMP (Figure 8)
The TEMP lamp illuminates if an over temperature
condition occurs within the Multimaster 160. This condition
may be caused by excessive duty cycle or over-current
conditions. When an over temperature condition occurs,
the welding output is turned off and the unit must be
allowed to cool. The machine will automatically reset when
the temperature falls to a safe level.
4.1.3 PROCESS SELECTOR SWITCH (Figure 8)
The three position process selector switch is located in
the upper left-hand corner of the control panel. The pro-
cess selector switch provides the visual indication of which
process (STICK, TIG, MIG) has been selected.